Installation Instructions

Installation Instructions for Vinyl Decals
Important Information : Please read these instructions all way through before starting.

You will need paper towels, squeegee and window cleaner. Measuring tape and masking tape are recommended but not required.

For best results:
- Surface temperature should be above 50 degrees F. and below 90 degrees F. If necessary move vehicle to a location where the temperature can be within the installation guide lines.
- The surface must be clean and free of all waxes, oil and dirt.
-All stickers are designed to be installed on the outside of the vehicle.

These decals come to you in three layers. The top layer is called transfer tape. It looks somewhat like regular masking tape. The middle layer is the actual decal. The bottom layer is a backing paper treated with a release agent.

Step 1
Clean Window ( or other surface ) thoroughly. Be sure to turn the cloth several times to insure thorough cleaning and wax removal

Step 2
Place graphic on desired surface and tape to the surface with masking tape across the top, creating a hinge.

Step 3
Flip graphic up and pull paper backing off, exposing adhesive

Step 4
Hold graphic tautly by the corners and flip back down so that adhesive is against surface.

Step 5
With firm pressure ( use driver license or credit card), rub graphic area from center out to edges forcing all air out. Any air bubbles will disappear.

Step 6
Wait a few minutes, then remove clear transfer tape by pulling straight back, leaving the graphic on the surface. If graphic comes of with the masking tape, repeat step 5 and wait a up to 24 hours before removing the masking tape.

Step 7
Take your fingers and check all edges and make sure they are tight. If you have an air bubble, use a pin and poke a small hole, allowing air to escape. The bubbles may disappear after a day or two. Once the decal touches the glass or paint, it cannot be moved again!